GENERAL SAFTY GUIDLINES FOR BATTERIES
NEVER use a NiCd/NiMH charger to charge Li-ion/LiPo batteries. Use a charger designed for charge LiPo/Li-ion batteries only.
ALWAYS inspect the battery to ensure there are no signs of damage, deformity, or swelling before charging. If there are, do not continue charging the battery, and follow the proper procedures to dispose of the battery.
ALWAYS charge batteries in a fireproof container and away from combustible material. Do not charge on surfaces that can catch fire – this includes; wood, cloth, carpet, or in the application’s device.
NEVER charge batteries unattended. Always remain in constant observation of the charging process & react to potential problems that may occur.
NEVER charge a deformed, swollen or ballooned battery. Continuing to charge a battery that has begun to swell will result in a fire. Follow these steps:
STOP the charging process by unplugging the charger, and disconnect the battery from it immediately
Disconnect battery from the device immediately
Place it in an open non-flammable area
Watch it for approx. 30 minutes from a safe distance
Follow proper procedure to dispose of battery
NEVER allow the battery’s positive and negative leads to touch.
If for any reason you need to cut the terminal wires of an assembled Li-ion/LiPo battery pack, it will be necessary to cut each wire separately, ensuring the wires to not touch each other or a short may occur.
Store Li-ion batteries in a cool, dry place between 40-80° F.
NEVER store Li-ion/LiPo batteries in any locations that can exceed these temperatures such as a vehicle, garage, or in the sun.
Keep your batteries out of reach of children and pets.Avoid Over-Discharging Li-ion/LiPo Batteries
Over-discharging a Li-ion/LiPo Battery, or continuing to use the battery even after it is fully depleted (e.g. when it is below its minimum voltage level), can cause permanent damage to your battery.While you’re not able to visibly detect the internal damage to the battery, it can eventually cause a fire when attempting to re-charge at a later time.To avoid over-discharging your battery, please make sure that your charger has a built-in protection circuit board (PCB). A standard PCB offers 4 major protective functions, namely, protection against over-charging, over-discharging, short-circuit and over-current.
Caution – Before Charging
Visually inspect your Li-ion/LiPo battery for any damaged leads, connectors, shrink wrap, swelling of cells, or other irregularities.
If you find any of the above issues with your pack, stop using it at once.
Check the voltage on the battery label and make sure it matches what is required by the device it powers, or that it matches an older battery you are replacing.
Charging LiPo Batteries
NEVER leave batteries charging unattended.
Always remain in constant observation of the charging process and react to potential problems that may occur.
Only charge batteries in a fireproof location. Never charge on wooden surfaces, cloth, carpet, or materials that can catch fire.
Allow the battery to cool down to ambient temperature before charging.
Do not charge multiple battery packs simultaneously by connecting them in series. Charge each battery pack individually. Failure to do so may result in incorrect battery recognition and charging functions. Overcharging may occur and result in fire.
When using a battery charger that can support multiple voltage outputs, select the cell count and voltage as it appears on the Li-ion/LiPo battery label. Selecting a cell count or voltage other than the one printed on the label will cause improper charging rates that can lead to fire.
As a safety precaution, confirm the information printed on the battery is correct.
· Example: The label on a 2-Cell battery pack in series will read – “7.4V” – You must select 2-Cell for charging.
· Example: The label on a 3-Cell battery pack in series will read – “11.1V” – You must select 3-Cell for charging.
In most cases, the charger’s charging current should not exceed 1C, unless otherwise noted. A higher setting may damage the battery and cause a fire.C-rating is a standard which defines a battery’s operating current based on its capacity. 1C is the current it takes to approximately fully discharge a battery in 1 hour, and is simply defined by dropping the “h” in the pack’s capacity (e.g. 1C for a 1000mAh LiPo battery is 1000mA, or 1A).
Some Li-ion/LiPo chargers in the market may contain insufficient or incorrect information regarding the battery packs they are designed for. It is the user’s responsibility to ensure that the charger purchased is compatible with your battery.
BATTERY MAINTENANCE AND HANDLING
Never disassemble existing Li-ion/LiPo battery packs to mix with other Li-ion/LiPo cells/packs.
Only charge your Li-ion/LiPo battery with a good quality, dedicated Li-ion/LiPo charger. A poor-quality charger may not be able to charge or protect your battery properly and can be dangerous.
Do not discharge the battery to a level below 3V per cell under load. Deep discharge below 3V per cell can deteriorate battery performance.
Charge: 32 to 113°F
Discharge: 32 to 140°F
Let battery cool down to ambient temperature before charging.
During discharge and handling of batteries, do not exceed 160°F.
STORANGE AND TRANSPORTATION
Never store batteries near an open flame or heater.
Store battery at room temperature between 40 and 80°F for best results.
Do not expose battery pack to direct sunlight (heat) for extended periods of time
When transporting or temporarily storing in a vehicle, temperature range should be greater than 20 °F but no more than 150°F.
Storing battery at temperature greater than 170°F for extended periods of time (more than 2 hours) may cause damage to battery and possible fire.
For long term storage, do not store them fully charged; it is recommended to fully charge and then discharge it to 50-60% of their capacity.
BATTERY LIFE & DISPOSAL OF LIPO BATTERIES
Rechargeable Li-ion/LiPo batteries do not last indefinitely. Batteries that have lost 20% of their initial capacity should be removed from service and disposed of properly.
If at any time you detect any physical damage to a Li-ion/LiPo battery such as swollen cell, split, battery leak, or tear in the LiPo cell’s foil covering, STOP and do not continue discharging the battery.
PPROPER DISPOSAL OF LI-ION/LIPO BATTERIES
Regulations and laws pertaining to the recycling and disposal of Li-ion/LiPo batteries vary from country to country as well as by state and local governments. You should check the laws and regulations where you live.
There are a number of facilities that recycle Li-ion/LiPo batteries. The Rechargeable Battery Recycling Corporation’s web site, , is an excellent source for finding a facility to handle these types of batteries. If you are not sure if your waste facility can handle Li-ion/LiPo batteries, contact them and verify if they are permitted or not.
Remember that before any type of disposal the batteries should be discharged completely. Tape the contacts with electrical tape and package so as to prevent contacts accidentally coming together at any time
For home disposal, many stores offer free recycling of rechargeable batteries. If no outlet is available in your area, it is safe to dispose of these batteries in your regular trash. As always, check with your local laws to make sure that this is acceptable.
Product warranty is limited to original defects in material and workmanship. Warranty does not cover collateral damage. Due to the nature and use of this product, there is no term warranty. Misuse, abuse, incorrect charging, failure to comply with the above warnings and guidelines, and other inappropriate use of this product are not covered under warranty.